On the 1998 Discovery 1 in my Land Rover collection, the brake lights would stay on! Clearly this is a safety issue when driving, as it appears you are always braking. I got around to investigating and discovered the switch...
Category - Land Rover
Jason Miller’s adventures with his Land Rovers.
Land Rovers are very picky about the charge of a battery too start them, especially the L322 Models and in this case a 2003 Land Rover Range Rover full-size HSE. I had tremendous success with the smaller panels for the Land Rover...
Swapping the battery on the L322 Range Rover isn’t hard if you approach it right. Spend the 60 seconds to properly lift the hood and latch so it’s 100% upright, as I show in this video. Have a step stool, so you can...
My 2007 Land Rover Range Rover L322 was throwing a few errors. As a result, I replaced the MAF sensor and the air filter. This video, while lengthy, goes in-depth to show just how easy it is to replace the MAF sensor.
It’s done! Well, done enough to be road-ready! Still needs minor things done, but don’t all Land Rovers need that? This is the 2003 Land Rover Range Rover with the BMW V8 that I saved from the junkyard. After lots of...
Slowly but surely, we are making progress on the head gaskets on the 1998 Land Rover Discovery 1. Below is the most recent progress picture!
I’ve had this on my list well over a year and with cold weather her it was time for me to tackle the job. It’s very quick and easy, but this video will serve as a guide to preparing you prior to the job. I ordered the...
As you may know, I like to buy Land Rovers to add to my collection and future automobile museum. Last year, I went to Mecum in Harrisburg Pennsylvania, it was a blast. I purchased some automobilia. This year, to kick things off...
Continued progress on the 1998 Land Rover Discovery 1 head gasket job! Major props to Caleb for getting this done for me! Below are some progress pictures.
Restoring these old Discovery 1’s is a journey. What started out as a bad wire between the wiring harness and the crank sensor led to a lot of other work. Turns out, the exhaust manifold stud is cracked and it’s best...